Exterior Mirror Glass

Exterior Mirror Glass

Removal

Vehicles with Blind Spot Information System (BLIS(R))

1. Position the exterior mirror glass in the full down position.

2. WARNING: Place a shop towel between the hands and the exterior mirror glass for protection in case of glass breakage during mirror service. Failure to follow this instruction may result in serious personal injury.

Pull the upper edge of the exterior mirror glass outward and then upward to release the locking tabs from the exterior mirror motor.





3. Disconnect the electrical connectors from the exterior mirror glass.

Vehicles with integrated spotter mirror

4. Position the exterior mirror glass to the full upward and inboard position and insert a thin, flat-blade screwdriver.





5. WARNING: Place a shop towel between the hands and the exterior mirror glass for protection in case of glass breakage during mirror service. Failure to follow this instruction may result in serious personal injury.

NOTE: LH mirror and motor removed from the housing and viewed from the back to show location of clips and placement of screwdriver.

Using the thin, flat-blade screwdriver, remove the exterior mirror glass by releasing the tabs. Starting at the lower outboard side of the mirror and continuing to the lower inboard side.





6. If equipped, disconnect the electrical connectors and remove the exterior mirror glass.

Installation

Vehicles with Blind Spot Information System (BLIS(R))

1. If equipped, connect the electrical connectors to the exterior mirror glass.





2. Install the lower exterior mirror glass onto the exterior mirror motor.

3. Position the exterior glass upward.

4. WARNING: Place a shop towel between the hands and the exterior mirror glass for protection in case of glass breakage during mirror service. Failure to follow this instruction may result in serious personal injury.

NOTE: An audible click will be heard during installation.

Place a hand against the back of the exterior mirror and a hand flat against the upper exterior mirror glass and press the exterior mirror glass into the upper exterior mirror motor retainers.

Vehicles with integrated spotter mirror

5. If equipped, connect the electrical connectors.

6. WARNING: Place a shop towel between the hands and the exterior mirror glass for protection in case of glass breakage during mirror service. Failure to follow this instruction may result in serious personal injury.

Position the exterior mirror glass onto the exterior mirror motor.

7. NOTE: An audible click will be heard during installation.

Firmly press the exterior mirror glass until it snaps onto the exterior mirror motor.

8. Rotate the exterior mirror glass in all directions after the installation to make sure that all of the exterior mirror glass retaining clips are completely fastened.