Flexplate

Flexplate





Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Jacking and Lifting Service and Repair.

2. Remove the transaxle. For additional information, refer to Automatic Transaxle/Transmission - Aisin AW21 Removal.

3. NOTE: One of the 8 flexplate holes are offset so the flexplate can only be installed in one position.

Remove the bolts and the flexplate.

- To install, tighten to 80 Nm (59 lb-ft).

4. To install, reverse the removal procedure.

5. Using the scan tool, perform the Misfire Monitor Neutral Profile Correction procedure, following the on-screen instructions.