Backup Lamp Switch: Service and Repair

Reversing Lamp Switch









Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Jacking and Lifting Service and Repair.

2. Remove the fasteners and the lower engine splash shield.

3. NOTE: Discard the reversing lamp switch gasket.

Disconnect the electrical connector and remove the reversing lamp switch.

- To install, tighten to 24 Nm (18 lb-ft).

4. To install, reverse the removal procedure.
- Install a new reversing lamp switch gasket.

- Check the transmission fluid and fill as necessary. For additional information, refer to Manual Transaxle/Transmission Procedures.