Accessory Protocol Interface Module Programming

Accessory Protocol Interface Module (APIM) Programming





Accessory Protocol Interface Module (APIM) Programming Using the Integrated Diagnostic System (IDS)

NOTE:

- If a new Accessory Protocol Interface Module (APIM) is being installed, install a new APIM before carrying out the following procedure. For additional information, refer to Information and Entertainment Systems Accessory Protocol Interface Module (APIM).
- When carrying out the programming procedures, follow the scan tool on-screen directions.
- Make sure the battery is fully charged before carrying out the programming steps.
- A hardwired internet connection is strongly recommended when programming.
- If unable to complete programming because operation stops or errors are received, internet browser settings may need to be configured. From the on-line OASIS tab, select the "Service Tips" tab, then select "SYNC Software Programming" under "Job Aids".

NOTE:

- For APIM flash programming:
- The scan tool and a USB male A to male A cable (CCMUSB2-AM-AM-10 or equivalent) are required.
- The flash procedure deletes any paired phones that were in the SYNC(R) system.
- The file for the flash needs to be downloaded from the online database. Allow for extra time for the file to download. The files are approximately 80 megabyte.

1. NOTE: The IDS program must be closed before attempting to program the APIM.

Open a session for the vehicle from the technician service publication web site, and run On-Line Automotive Service Information System (OASIS) using "Read VIN and DTC's".

2. From the OASIS tab, select the "SYNC" button.

3. There are 3 available options for APIM programming:
- Standard (latest version of current software and applications): Use this option to update the APIM to the latest software level.

- Custom (show what's available, and let me choose): Use this option to show all the available options that can be programmed, or if a Technical Service Bulletin (TSB) directs for specific software version to be programmed.

- Module Replacement (restore software for newly installed hardware): Use this option when the APIM has been replaced.

4. After selecting 1 of the 3 options (Standard, Custom or Module Replacement), click the "Read SYNC" button to verify the current APIM, Vehicle Interface Processor (VIP) and Consumer Interface Processor (CIP) software levels.
- The versions are compared to a online database. After the comparison, the available software is displayed.

5. NOTE: Do not disconnect the Vehicle Communication Module (VCM) or the USB cable during APIM programming.

When carrying out the programming procedures, follow the scan tool on-screen directions.

NOTE: If unable to complete programming because operation stops or errors are received, interned browser settings may need to be configured. From the on-line OASIS tab, select the "Service Tips" tab, then select "SYNC Software Programming" under "Job Aids".

Select the "Program SYNC" button to begin the APIM programming process.

6. Follow the scan tool on-screen directions for APIM programming.

- After programming is complete the scan tool displays "Programming has been completed successfully."