Fender Splash Shield - RH

Fender Splash Shield - RH









Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Jacking and Lifting Service and Repair.

2. Remove the battery. For additional information, refer to Battery, Mounting and Cables Battery.

3. Remove the windshield washer reservoir. For additional information, refer to Wipers and Washers Service and Repair.

4. Remove the battery tray bolt.
- To install, tighten to 12 Nm (106 lb-in).

5. Remove the 2 bolts and the fender splash shield.
- To install, tighten to 12 Nm (106 lb-in).

6. To install, reverse the removal procedure.