Seat Track

Seat Track

Removal and Installation

WARNING: Never disassemble or tamper with safety belt buckle/retractor pretensioners or adaptive load limiting retractors or probe the electrical connectors. Failure to follow this instruction may result in the accidental deployment of the safety belt pretensioners or adaptive load limiting retractors which increases the risk of serious personal injury or death.

All seats

1. Remove the seat. For additional information, refer to Seat - Front Seat - Front.

2. Remove the safety belt buckle.
- Disconnect the electrical connector.

- Remove the nut and safety belt buckle.
- To install, tighten to 48 Nm (35 lb-ft).

3. Release the rear outboard cushion J-clips.





4. Release the cushion trim cover rear J-clip.





5. Release the cushion trim cover rear hook-and-loop strip.





6. Detach the seat track motor electrical connector.





Driver seat

7. Disconnect the seat position sensor electrical connector.





All seats

8. Remove the 2 recliner-to-seat track bolts.
- To install, tighten to 55 Nm (41 lb-ft).

9. Remove the pivot bolt.
- To install, tighten to 45 Nm (33 lb-ft).

10. Remove the 4 seat track-to-cushion frame bolts.
- To install, tighten to 20 Nm (177 lb-in).

11. Remove the seat track and disconnect any electrical connectors still attached.

12. To install, reverse the removal procedure.