Rear Seat

Seat Backrest - Rear









Removal and Installation

1. Remove the rear seat cushion. For additional information, refer to Seat Cushion - Rear Seat Cushion - Rear.





2. If equipped, disconnect the backrest wiring harness electrical connectors.
- Label the electrical connectors to aid installation.





3. Remove the 2 nuts and rear seat backrest.
- To install, tighten to 55 Nm (41 lb-ft).

4. WARNING: The retaining wires in the rear seat cushion foam pad and frame, and rear seat backrest foam pad and frame must be fully seated in the retainer brackets to prevent the seat backrest and seat cushion from sliding forward in the event of a crash. Failure to follow these instructions may increases the risk of serious personal injury or death in a crash.

NOTE: Make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.

To install, reverse the removal procedure.