Lighting Control Module (LCM)

Lighting Control Module (LCM)









Removal and Installation

NOTE: Prior to removal of the module, it is necessary to upload the module configuration to a scan tool. This information needs to be downloaded into the new module once installed. For additional information, refer to Module Configuration Programming and Relearning.

1. NOTE: This step is necessary only if a new Lighting Control Module (LCM) is being installed.

Upload the module configuration information from the LCM into the scan tool. For additional information, refer to Module Configuration Programming and Relearning.

2. NOTE: A new LCM is delivered in a manufacturing mode with pre-set DTC B2477. This DTC clears when the module has been successfully configured (or Programmable Module Installation (PMI)). DTC B2477 may need to be cleared after a successful configuration (or PMI).

Remove the pin-type retainers and position the LH instrument panel lower insulator aside.

3. Disconnect the courtesy lamp and remove the LH instrument panel lower insulator.

4. Remove the accelerator pedal. For additional information, refer to Acceleration Control Accelerator Pedal.

5. Remove the 2 screws and position the LCM aside.

6. Release the locking tabs, disconnect the electrical connectors and remove the LCM.

7. NOTE: Once the new module is installed, it is necessary to download the module configuration information from the scan tool into the new module. For additional information, refer to Module Configuration Programming and Relearning.

To install, reverse the removal procedure.