Fuel Tank - L-Shaped

Fuel Tank - L-Shaped





Removal and Installation

WARNING: Do not smoke, carry lighted tobacco or have an open flame of any type when working on or near any fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.

WARNING: Do not carry personal electronic devices such as cell phones, pagers or audio equipment of any type when working on or near any fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.

WARNING: Before working on or disconnecting any of the fuel tubes or fuel system components, relieve the fuel system pressure to prevent accidental spraying of fuel. Fuel in the fuel system remains under high pressure, even when the engine is not running. Failure to follow this instruction may result in serious personal injury.

WARNING: When handling fuel, always observe fuel handling precautions and be prepared in the event of fuel spillage. Spilled fuel may be ignited by hot vehicle components or other ignition sources. Failure to follow these instructions may result in serious personal injury.

WARNING: Always disconnect the battery ground cable at the battery when working on an evaporative emission (EVAP) system or fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.

1. With the vehicle in NEUTRAL, position it on a hoist.

2. Drain the fuel tank.

3. Remove the muffler and tail pipe assembly.

4. NOTE: Some residual fuel may remain in the fuel tank filler pipe after draining the fuel tank. Carefully drain any residual fuel into a suitable container.
Release the clamp and remove the fuel tank filler pipe hose from the fuel tank.

- To install, tighten to 3 Nm (27 lb-in).


5. Disconnect the fuel vapor tube assembly-to-fuel tank filler pipe recirculation tube quick connect coupling.

6. Disconnect the fuel tank jumper tube-to-fuel tube quick connect coupling.

7. Release the fresh air hose vent cap and pin-type retainer from the body.

8. NOTE: Clean the Evaporative Emission (EVAP) canister vent solenoid electrical connector and the immediate surrounding area of any dirt or foreign material.
Disconnect the EVAP (Evaporative Emission) canister vent solenoid electrical connector.


9. Disconnect the fresh air hose-to-dust separator fitting.

10. Disconnect the fuel vapor tube assembly-to-EVAP (Evaporative Emission) canister quick connect coupling.

11. Position the Powertrain Lift under the fuel tank.

12. NOTE: Do not bend or distort the fuel tank straps.
Remove the 4 bolts and the 2 fuel tank straps.

- To install, tighten to 35 Nm (26 lb-ft).


13. Carefully lower and remove the fuel tank from the vehicle.

14. To install, reverse the removal procedure.