Window Glass - Rear Door

Window Glass - Rear Door

Removal and Installation

NOTE: The window motor must be de-initialized, then initialized whenever the window motor is removed from the window regulator drum housing, a new window regulator is installed, a new window glass is installed, a new top run is installed or for any operation in which grease or lubricants are applied to the window regulator or glass run.

1. Remove the rear door fixed glass. For additional information, refer to Window Glass- Fixed, Rear Door .

2. Temporarily install the window control switch and position the window glass to access the glass-to-regulator clamp locking tab.

3. Using a suitable tool, push the glass-to-regulator clamp locking tab inward then gently lift the glass upward slightly to release the glass from the regulator clamp.
- To install, gently push glass down into the clamp until an audible click is heard, indicating the glass has seated correctly into the glass clamp.


4. Remove the door window glass out through the top outboard side of the door.

5. To install, reverse the removal procedure.
- De-initialize, then initialize the window motor. For additional information, refer to Window Motor Initialization .