150000 MI or 240000 KM

Inspect
    Wheels
      Inspect wheels and related components for abnormal noise, wear, looseness or drag.
    Vehicle
      Perform multi-point inspection (recommended).
    Universal Joint, Drive/Propeller Shaft
      Inspect rear axle and U-joints; lubricate if equipped with grease fittings (AWD vehicles)
    Tie Rod End
    Tie Rod Boot
    Steering and Suspension
      Inspect steering linkage, ball joints, suspension, tie-rod ends, driveshaft, and U-joints; lubricate if equipped with grease fittings.
    Exhaust System
      Inspect exhaust system and heat shields.
    Cooling System
      Inspect engine cooling system strength and hoses.
    Constant Velocity Joint Boot
      Inspect half-shaft boots (if equipped).
    Brakes and Traction Control
      Inspect brake pads, shoes, rotors, drums, brake linings, hoses and parking brake.
    Ball Joint
      Inspect steering linkage, ball joints, suspension, tie-rod ends, driveshaft, and U-joints; lubricate if equipped with grease fittings.
Replace
    Oil Filter, Engine
    Fluid Filter - A/T
    Fluid - M/T
      Change manual transmission fluid. Change manual transmission fluid. If using special operating condition D.
    Fluid - A/T
      Change automatic transmission fluid and filter.
    Filters
      Replace climate-controlled seat filter (if equipped).
    Engine Oil
      Change engine oil and filter.
    Drive Belt
      Replace accessory drive belt(s) if not replaced within the last 100,000 miles (160,000 km).
    Coolant
      Change engine coolant. Initial replacement at 6 years or 100,000 miles (160,000 km), then every 50,000 miles (80,000 km).
    Cabin Air Filter / Purifier
      Inspect cabin air filter (if equipped). Change cabin filter when using Special Operating conditions D, I.
    Air Filter Element
      Change engine air filter if using Special Operating conditions D, I. Replace engine air filter. If using normal condition.
Rotate
    Tires
      Rotate tires, inspect tire wear and measure tread depth.