Seat Armrest - Rear

Seat Armrest - Rear

Removal and Installation

All vehicles

1. Remove the 60 percent rear seat backrest. For additional information, refer to Seat Backrest- Rear Seat Backrest - Rear.

Hybrid vehicle

2. Remove the 2 pin-type retainers and the duct end seal.





All vehicles

3. Separate the 4 pin-type retainers attaching the armrest pocket cover to the backrest frame.





4. Remove the armrest assembly.
1. Disengage the backrest cover lower J-strips.

2. Remove the 4 armrest-to-backrest bolts and armrest assembly.
- For installation, adjust the armrest horizontally as needed for good fit.

- To install, tighten to 10 Nm (89 lb-in).







5. Disassemble the armrest assembly in the following sequence.
1. Remove the cup holder rubber insert.

2. Remove 2 pin-type retainers and the cup holder.

3. Remove 2 armrest pivot bolts and armrest bracket.
- To install, tighten to 10 Nm (89 lb-in).

4. Release the armrest cover clip, invert and remove.


6. To install, reverse the removal procedure.