Cruise Control - Intermittent or Inoperative

Bulletin No.
012/92

Issued
7/14/92

Revised



Category
T



Applicable Model/s
1991 Navajo



Subject
CRUISE CONTROL INTERMITTENT OR INOPERATIVE



DESCRIPTION

Intermittent or inoperative cruise control operation may occur during wet weather conditions because of corrosion in the cruise control actuator connector.


INSPECTION & REPAIR PROCEDURE

Inspect the connector at the cruise control actuator. If any pins are corroded, replace as necessary. Refer to the following procedure for details.






1. Disconnect the connector (N-04) at the actuator. Figure 1.

2. Blow dry the connector assembly with shop air.

3. Clean and inspect the connector pins for corrosion.

4. Replace any damaged or corroded pins (ZZL0 FF 012).

5. Apply dielectric grease to both ends of the connector to prevent any further water entry.

6. Reconnect the connector (N-04) to the actuator.

PARTS INFORMATION

PART NUMBER DESCRIPTION

ZZL0 FF 012 Pin Connector


WARRANTY INFORMATION
(Applies to vehicles covered under warranty.)

Warranty Type Code:
A

Customer Comment Code:
55

Damage Code:
93

Part No. of Main Cause:
ZZL0 FF 012

Operation No.:
YY0055RX

Labor Hours:
0.3 Hr.