Oil Pressure Test

1. Remove the oil pressure sensor.





2. Screw SST# 49 0187 280, oil pressure gauge, into the oil pressure sensor installation hole.
3. Warm up the engine to normal operating temperature.
4. Run the engine at 2000 rpm, and note the gauge readings.

Oil pressure: 276-413 kPa (40-60 psi) @ 2,000 rpm

5. If the pressure is not as specified, check for the cause and repair as necessary. Trouble Shooting Guide





6. Apply sealant to the oil pressure sensor threads as shown.
7. Remove the SST and install the oil pressure sensor.
Tightening torque: 11-24 Nm (8-18 ft. lbs.)