Crankshaft Position Sensor: Service and Repair
Removal1. Disconnect the negative battery cable.
2. Raise vehicle on a hoist. (3.0L only).
3. Disconnect the crankshaft position sensor harness connector from the wiring harness.
4. Remove the crankshaft position sensor screws and remove the sensor.
Installation
1. Position the crankshaft position sensor on engine.
2. Install the two sensor screws.
CAUTION
^ Do not overtighten crankshaft position sensor screws.
Tightening torques:
3.0L: 5 - 7 N.m {46 - 70 kgf.cm, 40 - 61 in.lbf}
4.0L: 9 - 12 N.m {92 - 121 kgf.cm, 75 - 106 in.lbf}
3. Lower vehicle. (3.0L only).
4. Route the sensor harness and connect the harness connector.
5. Connect the negative battery cable.