Seat Backrest Front - Bucket and 40 Percent Disassembly/Assembly

SEAT BACKREST FRONT - BUCKET AND 40 PERCENT DISASSEMBLY/ASSEMBLY






Disassembly

WARNING:
- The safety belt pretensioner is a pyrotechnic device. Always wear safety glasses when repairing an air bag equipped vehicle and when handling a safety belt buckle pretensioner or safety belt retractor pretensioner. Never probe a pretensioner electrical connector. Doing so could result in pretensioner or air bag deployment and could result in personal injury.
- To reduce the risk of personal injury, do not use any memory saver devices.

NOTE:
- If a seat equipped with a supplemental restraint system (SRS) component is being serviced, the SRS must be depowered.
- The air bag warning lamp illuminates when the restraint control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a SRS fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
- Driver seat shown, passenger seat similar.

All seats
1. Depower the SRS.
2. Remove the affected seat.
3. Remove the affected seat backrest.






4. Release the backrest J-clip.






CAUTION: Use care when separating the seat back trim cover from the hook and loop strips or the hook and loop strips may be torn from the seat back foam.

5. Release the hook and loop strips and invert the backrest cover and remove all the hog rings.
6. Remove the backrest trim cover and the backrest foam pad.

Seats with manual lumbar






7. Remove the lumbar support assembly.
1. Remove and discard the tie strap.
2. Flex the lumbar support.
3. Unhook the lumbar support adjusting cable.
4. Unhook and remove the lumbar support adjusting cable.
5. Detach the lumbar support from the guide wires. Remove the lumbar support.

Assembly

Seats with manual lumbar






1. Install the lumbar support assembly.
1. Install the lumbar support. Attach the lumbar to the guide wires.
2. Install and hook the lumbar adjusting cable.
3. Flex the lumbar support.
4. Hook the lumbar support cable.
5. Install the tie strap.

All seats
2. Install the backrest trim cover on the backrest foam pad.






3. Install the hog rings and secure the hook and loop strips.






4. Attach the backrest J-clip.
5. Install the affected seat backrest.
6. Install the affected seat.
7. Repower the SRS.