Engine Controls - Cold Start High Idle Speed
Bulletin No: 01-007/10Last Issued: 01/15/2010
Subject:
HIGH IDLE AT COLD START OR DEPRESSING CLUTCH
BULLETIN NOTE
APPLICABLE MODEL(S)/VINS
DESCRIPTION
Customers having this concern should have their vehicle repaired using the following repair procedure.
REPAIR PROCEDURE
(Use Steps below for all models)
1. Reboot the IDS to clear memory before reprogramming.
2.
NOTE:
^ This bulletin does not apply to California Spec. vehicles.
^ Always update the IDS tool first, then follow on-screen instructions to download the needed calibration file for PCM reprogramming.
^ It is not necessary to remove any fuses or relays during PCM reprogramming when the IDS screen prompts you to do so. You may accidentally stop power to one of the PCM terminals and cause the PCM to be blanked, or you may receive error messages during the IDS reprogramming procedure.
^ IDS shows the calibration part numbers after programming the PCM.
^ Please be aware that PCM calibration part numbers and file names listed in any Service Bulletin may change due to future releases of IDS software, and additional revisions made to those calibrations for service related concerns.
^ When reprogramming a PCM, IDS will always display the latest" calibration P/N available for that vehicle. If any calibration has been revised/updated to contain new information for a new service concern/issue, it will also contain all previously released calibrations.
^ When performing this procedure, we recommend that a battery charger be installed on the vehicle battery and turned ON to a maximum charge of no more than 20 AMPS to keep the vehicle battery up to capacity. If you exceed 20 AMPS, it could damage the VCM.
3. After performing the PCM reprogramming procedure, verify the repair by starting the engine and making sure there are no MIL illumination or abnormal warning lights present.
NOTE:
^ If any DTCs should remain after performing DTC erase, diagnose the DTCs according to the appropriate Troubleshooting section of the Workshop Manual.
^ After PCM reprogramming, it is no longer necessary to road test the vehicle to relearn" KAM (Keep Alive Memory).
CALIBRATION INFORMATION
NOTE:
It is not necessary to order a PCM part for this repair procedure.
WARRANTY INFORMATION
NOTE:
^ This bulletin does not apply to California Spec. vehicles.
^ This warranty information applies only to verified customer complaints on vehicles eligible for warranty repair.
^ This repair will be covered under Mazda's New Vehicle Limited Warranty term for a Powertrain Component.
^ Additional diagnostic time cannot be claimed for this repair.
Disclaimer