Clutch Bleed Procedure-On-Vehicle
CLUTCH BLEED PROCEDURE-ON-VEHICLE1. Using the hydraulic line disconnect tool SST (T88T-70522-A) or equivalent, disconnect the quick connect fitting.
2. Press the internal mechanism of the quick connect fitting.
^ Slowly press the clutch pedal to the floor and hold.
3. Release the internal mechanism of the quick release fitting.
4. Repeat steps 2 and 3 four times.
5. Connect the quick connect fitting.
6. Close the clutch master cylinder reservoir.
^ Stroke the clutch pedal as fast as possible for five to ten strokes.
7. Wait one to three minutes.
^ Repeat step 6 three times.
8. Loosen the clutch slave cylinder bleeder screw.
^ Slowly press and hold the clutch pedal.
9. Tighten the clutch slave cylinder bleeder screw. Release the clutch pedal.