Pilot Bearing: Service and Repair
PILOT BEARING REMOVAL / INSTALLATION1. Remove the transmission.
2. Remove the clutch disc and the clutch cover.
3. Using impact slide hammer SST (307-005) and pilot bearing remover SST (308-001) or equivalent, remove the pilot bearing from the crankshaft.
4. Inspect the transmission input shaft pilot bearing for:
^ misalignment and looseness in the flywheel.
^ needle rollers for scoring, worn or broken needle rollers, inadequate grease or discoloration.
^ seal leakage.
Note:
^ The transmission input shaft pilot bearing can only be installed with the seal facing the transmission. The transmission input shaft pilot bearing is lubricated and does not require additional lubrication. A new transmission input shaft pilot bearing must be installed whenever it is removed.
5. Using a soft-face hammer and the pilot bearing installer SST (308-105) or equivalent install the new transmission input shaft pilot bearing into the crankshaft.
6. Install the clutch disc and clutch cover.
7. Install the transmission.