Seat Track Front - 60 Percent Bench Removal/Installation

SEAT TRACK FRONT - 60 PERCENT BENCH REMOVAL/INSTALLATION

Removal

WARNING:
- The safety belt pretensioner is a pyrotechnic device. Always wear safety glasses when repairing an air bag equipped vehicle and when handling a safety belt buckle pretensioner or safety belt retractor pretensioner. Never probe a pretensioner electrical connector. Doing so could result in pretens loner or air bag deployment and could. result in personal injury.
- To reduce the risk of personal injury, do not use any memory saver devices.

NOTE:
- If a seat equipped with a seat mounted side air bag and/or a safety belt pretensioner (if equipped) system is being serviced, the supplemental restraint system (SRS) must be depowered.
- The air bag warning lamp illuminates when the restraint control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a SRS fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

1. Depower the SRS.
2. Remove the effected seat.
3. Remove the 60 percent bench armrest.
4. Remove the 60 percent bench seat backrest assembly.






5. Remove the seat track spring.






6. Remove the push nuts.






7. Remove the seat track adjustment lever.
- Remove one side of the seat track adjustment lever at a time.






8. Remove the two rear seat cushion-to-frame bolts.






9. Remove the two front seat cushion-to-frame bolts and remove the seat track from the seat cushion frame.






10. Remove the eight nuts and separate the seat track from the seat cushion frame.

Installation






1. Install the seat track-to-cushion frame and install the eight nuts.






2. Install the two front seat cushion-to-frame bolts.






3. Install the two rear seat cushion-to-frame bolts.






4. Install the seat track adjustment lever.
- Install one side of the seat track adjustment lever at a time.






5. Install the push nuts.






6. Install the seat track spring.
7. Install the 60 percent bench seat backrest assembly.
8. Install the 60 percent bench armrest.
9. Install the effected seat.
10. Repower the SRS.