Seat Armrest Front - 60 Percent Bench Removal/Installation
SEAT ARMREST FRONT - 60 PERCENT BENCH REMOVAL/INSTALLATIONRemoval
WARNING:
- The safety belt pretensioner is a pyrotechnic device. Always wear safety glasses when repairing an air bag equipped vehicle and when handling a safety belt buckle pretensioner or safety belt retractor pretensioner. Never probe a pretensioner electrical connector. Doing so could result in pretensioner or air bag deployment and could result in personal injury.
- To reduce the risk of personal injury, do not use any memory saver devices.
NOTE:
- If a seat equipped with a seat mounted side air bag and/or a safety belt pretensioner (if equipped) system is being serviced, the supplemental restraint system (SRS) must be depowered.
- The air bag warning lamp illuminates when the restraint control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a SRS fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
1. Depower the SRS.
2. Remove the 60 percent bench seat.
3. Detach the safety belt buckle pretensioner electrical connector and wire harness anchor clips and route the wire harness through the seat frame.
4. Remove the safety belt buckle pretensioner cover screw and remove the cover.
5. Remove the nut and remove the safety belt buckle pretensioner.
6. Release the J-clips.
7. Release the rear armrest J-clip and the hook and loop strip and position material from around the tether anchor.
8. Lift the cushion cover and foam pad for access to armrest bolts.
9. Remove the four bolts and remove the armrest assembly.
10. Release the armrest bracket cover clips and slide the two covers off (one Shown).
11. Remove the two armrest bracket bolts (one shown) and remove the armrest.
Installation
1. Install the armrest and install the two armrest bracket bolts (one shown).
2. Install the armrest bracket covers.
3. Install the 4 armrest bolts.
4. Position the front seat cushion trim cover. Secure the hook and loop fastener.
5. Position the material around the tether anchor and attach the hook and loop strip and attach the rear armrest J-clip.
6. Attach the J-clips.
7. Install the safety belt buckle pretensioner and install the nut.
8. Install the safety belt buckle pretensioner cover and install the screw.
9. Route the safety belt buckle pretensioner wire harness through the seat and attach the harness clips and the electrical connector to the seat cushion pan.
10. Install the 60 percent bench seat.
11. Repower the SRS.