Four Wheel Drive Selector Switch: Service and Repair

TRANSFER CASE MODE SELECT SWITCH REMOVAL/INSTALLATION

Transfer Case Mode Select Switch Removal/Installation:

Removal and Installation

Caution:
- Before removing the audio unit, it must be placed in shipment mode. Failure to follow this instruction may result in damage to the audio unit

1. Put the audio unit in shipment mode.
2. Using the audio unit removing tool SST 415-001, remove the audio unit.
3. Disconnect the audio unit electrical connector(s) and antenna cable.
4. Remove the screws and pull out the instrument panel center finish panel out of the instrument panel.





5. Disconnect the finish panel electrical connectors.
6. Remove the mode select switch knob.





7. Remove the two screws retaining the switch, and remove the switch.





8. To install, reverse the removal procedure.