Removal and Replacement
COMBINATION SWITCH REMOVAL/INSTALLATIONWARNING: If the negative battery cable or the steering angle sensor connector is disconnected, the stored initial position of the steering angle sensor will be cleared and the DSC will not operate properly, making the vehicle unsafe to drive. Perform the steering angle sensor initialization procedure after connecting the negative battery cable.
1. Disconnect the negative battery cable.
2. Remove the following parts:
1. Driver-side air bag module
2. Steering wheel
3. Column cover
3. Remove in the order indicated in the table.
4. Disconnect the steering angle sensor connector.
5. Install in the reverse order of removal.
6. Perform the steering angle sensor reference point setting.