Input/Turbine Speed Sensor Inspection
INPUT/TURBINE SPEED SENSOR INSPECTION [AW6A-EL, AW6AX-EL]On-Vehicle Inspection
Caution
^ Water or foreign material entering the connector can cause a poor connection or corrosion. Be sure not to allow water or foreign material on the connector when disconnecting.
^ Do not damage the terminals.
1. Disconnect the negative battery cable.
2. Remove the air cleaner component.
3. Remove the TCM.
4. Verify that there is no continuity between the coupler component terminals B12 and GND or B13 and GND.
^ If there is any malfunction, inspect the coupler component.
^ If the coupler component is normal, perform an off-vehicle inspection of input/turbine speed sensor. (See Off-Vehicle Inspection.)
Note
^ Inspect with a tester that can indicate more than 10 megohms and confirm that the value is more than 1 megohm.
5. Verify that there is continuity between coupler component terminals B12 and B13.
^ If there is any malfunction, inspect the coupler component.
^ If the coupler component is normal, replace the input/turbine speed sensor.
6. Install the TCM.
7. Install the air cleaner component.
8. Connect the negative battery cable.
Off-Vehicle Inspection
Warning
^ A hot transaxle and ATF can cause severe burns. Turn off the engine and wait until they are cool before replacing the ATF.
Caution
^ Water or foreign material entering the connector can cause a poor connection or corrosion. Be sure not to allow water or foreign material on the connector when disconnecting.
^ Do not damage the terminals.
1. Disconnect the negative battery cable.
2. Remove the air cleaner component.
3. Remove the under cover.
4. Drain the ATF.
5. Remove the resonance chamber.
6. Remove the thermo valve.
7. Remove the control valve body.
8. Remove the input/turbine speed sensor.
9. Connect the input/turbine speed sensor terminal 2 to the battery positive terminal, connect the battery negative terminal to input/turbine speed sensor terminal 1 through an ammeter set to a resistance of 100 ohm.
10. Measure the current while waving a magnet back and forth over the top of the input/turbine speed sensor (less than 5 mm (0.197 in)).
^ If there is any malfunction, replace the input/turbine speed sensor.
Input/turbine speed sensor
Input/turbine Speed Sensor:
11. Install the input/turbine speed sensor.
12. Install the control valve body.
13. Install the thermo valve.
14. Install the resonance chamber.
15. Add ATF to the specified level.
16. Install the under cover.
17. Install the air cleaner component.
18. Connect the negative battery cable.
19. Perform the mechanical system test. (See Mechanical System Test [AW6A-EL, AW6AX-EL].) Mechanical System Test