Removal and Replacement

BATTERY AND BATTERY TRAY REMOVAL / INSTALLATION









WARNING:Batteries normally produce explosive gases. Therefore, do not allow flames, sparks, or lighted substances to come near the battery. When charging or working near a battery, always shield your face and protect your eyes. Always provide adequate ventilation. Failure to follow these instructions may result in personal injury.

WARNING:To avoid accidental deployment and possible injury, the backup power supply must be depleted before repairing or installing any front or side air bag supplemental restraint system (SRS) components and before repairing, installing, adjusting or striking components near the front or side air bag sensors, such as doors, instrument panel, console, door latches, strikers, seats and hood latches. To deplete the backup power supply energy, disconnect the negative battery cable and wait at least 1 minute. Be sure to disconnect any auxiliary batteries and power supplies (if equipped). Failure to follow these instructions may result in personal injury.

WARNING:When lifting a battery, excessive pressure on the end walls could cause acid to spew through the vent caps, resulting in personal injury. Lift with a battery carrier or with your hands on opposite corners. Failure to follow these instructions may result in personal injury.

WARNING:Keep out of the reach of children. Batteries contain sulfuric acid. Avoid contact with skin, eyes or clothing. Also, shield your eyes when working near the battery to protect against possible splashing of the acid solution. In case of acid contact with the skin or eyes, flush immediately with water for a minimum of 15 minutes and get prompt medical attention. If acid is swallowed, call a physician immediately. Failure to follow these instructions may result in personal injury.
NOTE:When the battery is disconnected and connected, some abnormal drive symptoms may occur while the vehicle relearns its adaptive strategy. The vehicle may need to be driven to relearn its strategy.
1. Disconnect the battery. See Procedures.

2. Remove the battery hold down bolt and clamp.Tightening Torque12 Nm {1.2 kgf-m, 9 ft-lbf}

3. Remove the battery heat shield (if equipped).

4. Remove the battery.

5. To install, reverse the removal procedure.