Wheel Speed Sensor - Front

-
WHEEL SPEED SENSOR - FRONT, 4WD









Removal and Installation

1. Remove the brake disc shield. See Service and Repair.

2. Disconnect the negative battery cable. See Procedures.

3. Disconnect the wheel speed sensor electrical connector.

4. Remove the wheel speed sensor harness bolt and unclip the retainers.

- To install, tighten to 15 N-m (1.5 kgf-m, 11 ft-lbf).

5. Remove the wheel speed sensor bolt and the wheel speed sensor.

- To install, tighten to 12 N-m (1.2 kgf-m, 9 ft-lbf).

6.
NOTE:Plug the sensor cavity and thoroughly clean the sensor mounting surface. Apply wheel bearing grease to the mounting surface.To install, reverse the removal procedure.