Cruise Control Switch Wiring Harness Removal / Installation

CRUISE CONTROL SWITCH WIRING HARNESS REMOVAL / INSTALLATION

1. Remove cruise control switches. See Cruise Control Switch Removal / Installation.

2. Disconnect steering wheel wiring harness connector at right side of steering wheel attaching bolt.

3. Remove steering wheel. See Service and Repair.

4. Disconnect wiring harness terminals from the two horn switches.

5. Remove right horn switch.

6. On back side of steering wheel, remove two screws and back cover.

7. Disconnect wiring harness.
NOTE:With steering wheel rim facing down on a bench, route wiring harness around steering wheel upper spokes to switch locations. Route wiring with black 5-pin air bag sliding contact connector from right cruise control switch through two retaining clips and through two wiring locating ribs beneath the right horn switch.
a. Route horn switch wires as follows:

- Wire from the right cruise control switch to the left horn switch and the wire from the left cruise control switch to the right horn switch.

b. Carefully route wiring between the locator posts and the top inside of the back cover.

8. To install, reverse the removal procedure.
Tightening torque: Horn switch screws
6.5-7.5 Nm {0.66-0.76 kgf-m, 4.8-5.5 ft-lbf}