Axle Assembly Front Removal / Installation

AXLE ASSEMBLY FRONT REMOVAL / INSTALLATION









1. Remove the front drive axle shaft; see Drive Shaft, Front Axle Removal / Installation.

2. Index the front propeller shaft to the companion flange.






NOTE:Do not allow the propeller shaft to hang unsupported.

3. Disconnect the front driveshaft from the companion flange.
1 Remove the four bolts and remove the universal joint spider retainers.
2 Disconnect the driveshaft.
3 Position the driveshaft aside.

4. Disconnect the axle vent tube.

5. Support the axle with a suitable jack.

6. Remove the left front axle to frame bolt and nut.






7. Remove the other two axle to frame bolts and nuts.






8. Remove the axle.

CAUTION:It is important to install the spacer, between the pinion arm bushing and the frame, in the same position as when removed.
NOTE:Use new fasteners when installing the front axle.
9. To install, reverse the removal procedure.