Keyless Control Module Removal/Installation [Advanced Keyless Entry And Start System]

KEYLESS CONTROL MODULE REMOVAL/INSTALLATION [ADVANCED KEYLESS ENTRY AND START SYSTEM]

1. If the keyless control module is replaced, always perform the following procedure.

- Keyless Control Module Configuration Keyless Control Module Configuration
- Immobilizer System-related Parts Programming[No.6 Programming Procedure Due to Keyless Control Module Replacement] Advanced Keyless Entry and Start System

2. Disconnect the negative battery cable.

3. Remove the front side trim. Front Side Trim Removal/Installation

4. Disconnect the keyless control module connector.

5. Remove the bolt, then remove the keyless control module.






6. Install in the reverse order of removal.