Hazard Warning Switch: Service and Repair
HAZARD WARNING SWITCH REMOVAL/INSTALLATION
CAUTION:
- The hazard warning switch cannot be reused because it is removed by prying out the connection part of the hazard warning switch panel and hazard warning switch. Do not remove the hazard warning switch except when replacing it.
Removal
1. Disconnect the negative battery cable.
2. Remove the following parts:
a. Front scuff plate inner Front Scuff Plate Removal/Installation
b. Front side trim Front Side Trim Removal/Installation
c. Console panel Console Panel Removal/Installation
d. Console Console Removal/Installation
e. Hood release lever Service and Repair
f. Lower panel Lower Panel Removal/Installation
g. Center panel Center Panel Removal/Installation
3. Remove the screws.
4. Disconnect the connector.
5. Turn the hazard warning switch off.
NOTE:
- Turning off the hazard warning switch provides better visibility of the connection area between the hazard warning switch and the hazard warning switch panel.
6. Insert a tape-wrapped flathead screwdriver in the position shown in the figure, lift it up in the direction of the arrow and shift the tab.
7. Pull out the hazard warning switch in the direction of the arrow shown in the figure.
CAUTION:
- If the hazard warning switch is forcefully removed, the hazard warning switch panel will interfere with the audio panel and cause scratching or other damage. When removing the hazard warning switch, pull it out while pressing the hazard warning switch panel.
8. Remove the hazard warning switch panel in the direction of the arrow shown in the figure.
Installation
1. Install in the order shown in the figure.
2. Install the following parts:
a. Center panel Center Panel Removal/Installation
b. Lower panel Lower Panel Removal/Installation
c. Hood release lever Service and Repair
d. Console Console Removal/Installation
e. Console panel Console Panel Removal/Installation
f. Front side trim Front Side Trim Removal/Installation
g. Front scuff plate inner Front Scuff Plate Removal/Installation
3. Connect the negative battery cable.