Accelerator Pedal Position Sensor: Testing and Inspection

ACCELERATOR PEDAL POSITION (APP) SENSOR INSPECTION [L3 WITH TC]

NOTE:
- Before performing the following inspection, make sure to follow the procedure as indicated in the troubleshooting flowchart. Description and Operation

Voltage Inspection

1. Turn the ignition switch to the ON position (Engine off).

2. Verify that the PCM terminal 1Y and 1AC change smoothly while throttle valve is gradually opened.

- If as verified, go to next step.
- If not as verified, perform the "Circuit Open/Short Inspection".

- If there is no open or short circuit, replace the throttle body. (See Service and Repair.)

3. Verify that the PCM terminal 1Y and 1AC voltages are as shown in the following table.






- If the voltage is not according to the following table, perform the "Circuit Open/Short Inspection".

- If there is no open or short circuit, replace accelerator pedal. (See Service and Repair.)
APP sensor output voltage









Circuit Open/Short Inspection









1. Disconnect the PCM connector. (See Service and Repair.)

2. Inspect the following wiring harnesses for an open or short circuit. (Continuity check)

Open circuit

- If there is no continuity, there is an open circuit. Repair or replace the wiring harness.

- APP sensor terminal A and PCM terminal 1AJ
- APP sensor terminal B and PCM terminal 1AV
- APP sensor terminal C and PCM terminal 1AC
- APP sensor terminal D and PCM terminal 1Q
- APP sensor terminal E and PCM terminal 1U
- APP sensor terminal F and PCM terminal 1Y

Short circuit

- If there is continuity, there is a short circuit. Repair or replace the wiring harness.

- APP sensor terminal A and body ground
- APP sensor terminal B and power supply
- APP sensor terminal C and power supply
- APP sensor terminal C and body ground
- APP sensor terminal D and body ground
- APP sensor terminal E and power supply
- APP sensor terminal F and power supply
- APP sensor terminal F and body ground