2006-2008 MX-5
2006-2008 MX-51. Dry the evaporator using the following procedure:
WARNING:
Running the engine inside an enclosed area, such as a garage, is dangerous. Exhaust gas, which contains poisonous carbon monoxide, could easily enter the cabin. Loss of consciousness or even death could occur. Don't run the engine when inside an enclosed area.
A. Start the engine.
B. Set the HVAC controls as follows:
^ Air source: re-circulate
^ Heater control: full heat
^ Fan: high
^ A/C switch: off
^ Airflow (Face)
C. Open one window approximately one half inch.
D. Let the engine run for 15 minutes.
2. Remove the glove box by:
A. Remove the dumper clip.
B. Bend the stoppers inward, then remove.
C. Turn the glove compartment downward and pull the pins.
3. Shake a bottle of Mazda Cooling Coil Coating well and attach it to the applicator, then connect the applicator to compressed shop air.
4. Insert the applicator in the grille of the the recirculation door. Point the nozzle tip downwards and towards center (approximately the 7 o'clock position).
5. Spray the entire contents of the bottle in short bursts, 3 seconds ON, 3 seconds OFF into the rotating fan. A fine mist may exit from the ducts.
6. When the bottle is empty, stop the engine and remove the applicator.
NOTE:
Clean the empty bottle by flushing it with clean water.
7. Use STEP 1 to dry and cure the product.
8. While the product is drying, re-install the glove box.
9. Note application date in service record.