Drive Gear Case Component Disassembly Procedure

Drive Gear Case Component Disassembly Procedure





1. Install the drive gear case component to the SST.





2. Tap the drive gear shaft using a suitable rod and hammer.





3. Take out the drive gear shaft from the drive gear case.





4. Make alignment marks on the bearing cap and drive gear case.
5. Remove the bearing cap.





6. Insert a flathead screwdriver into spacer notch and remove the adjustment shim.





Caution: Place a rag on the case to protect it from damage.





7. Remove the spacer.





8. Remove the drive gear component.





9. Using the SST, remove the oil seal (LH outer).





10. Using the SST, remove the oil seal (LH inner).





11. Using a suitable rod and hammer, remove the oil seal (RH outer).





12. Using the SST, remove the oil seal (RH inner).





13. Using the SST, remove the bearing outer race (LH).





1) Install the SSTs (49 W032 202, 49 S019 005).





2) Connect the SST (49 T032 316, 49 T032 317) to the SSTs (49 W032 202, 49 S019 005).





14. Remove the baffle plate.





15. Using the SST, remove the bearing (RH).





16. Using a flathead screwdriver, deform the bearing roller guide (LH) and remove it.





17. Using the SST, remove the bearing inner race (LH).