Theft-Deterrent System Initialization Procedure

THEFT-DETERRENT SYSTEM INITIALIZATION PROCEDURE

CAUTION:
- The initialization must be performed when the BCM is replaced with a new one. If the initialization is not performed, the transition time from the initial mode to the stand-by mode (approx. 20 s) cannot be set, resulting in the possibility of the theft-deterrent system activating immediately due to a mis-operation after an occupant gets out of the vehicle.

Theft-deterrent system initialization procedure





Verification after theft-deterrent system initialization

1. Turn the ignition switch to the ON position.

2. Fully lower the driver's door glass.

3. Turn the ignition switch to the LOCK position and remove the key.

4. Get out of the vehicle and close all the doors, hood, and liftgate.

5. Press the transmitter LOCK button to lock all the doors and liftgate.

6. Open the driver's door by turning the driver's door lock knob from the LOCK to UNLOCK position within approx. 10 s after Step 5 is performed and the hazard warning lights flash.

7. The initialization is completed unless a warning alarm is triggered.

NOTE:
- If a warning alarm is triggered, the transition time setting from the initial mode to stand-by mode 1 has not been completed. In this case, repeat the theft-deterrent system initialization procedure.