Advanced Key ID Code Registration

ADVANCED KEY ID CODE REGISTRATION [ADVANCED KEYLESS ENTRY AND START SYSTEM]

CAUTION:
- Do not place the following devices in the vehicle while programming, otherwise programming cannot be performed.

- M-MDS
- Personal computer
- Device that can send/receive radio waves
- Verify that the other transmitter is not being operated around the servicing area during advanced key programming.

NOTE:
- Use the M-MDS and start programming if the condition corresponds to the following:

- One or No Programmed Advanced Keys
- Keyless control module is replaced
- If six advanced keys are already programmed, the programming mode does not activate. If programming is needed, use the M-MDS to erase the unnecessary advanced key programming.

With two programmed advanced keys

1. Bring the programmed advanced keys (2) and a unprogrammed advanced key into the vehicle.

2. Close all doors.

3. Insert the supplementary key into the ignition key cylinder.
NOTE:
- Complete the procedures up to Step 7 within 30 s after the supplementary key is inserted.

4. Turn the ignition switch to the ON position.

5. Press the UNLOCK button on advanced key 1.

6. Press the UNLOCK button on advanced key 2.

7. From the ignition switch in the ON position, switch the ignition switch in the order indicated below.

- ACC-->ON-->ACC-->ON-->ACC-->ON

8. Open the driver-side front door, press the door switch twice, and then close the door.
NOTE:
- After Step 3 is completed and the advanced key programming mode is activated, the door lock actuator operates to lock, and then operates to unlock.
- If the door lock actuator does not operate, repeat the procedure from Step 2.

9. Press the UNLOCK button on the unprogrammed advanced key twice.
NOTE:
- After Step 8 is completed and the advanced key is programmed, the door lock actuator operates to lock, and then operates to unlock.

10. If programming more advanced keys, remove the supplementary key once, and then repeat the procedure from Step 2.

Using M-MDS

1. Fully lower the driver-side door glass.

2. Connect the M-MDS to the DLC-2.






3. Set the M-MDS outside the vehicle with its cable passing through the door glass opening.

CAUTION:
- Cover the vehicle body with a clean rag so as not to damage the vehicle body with the cable.

4. After the vehicle is identified, select the following items from the initial screen of the M-MDS.

- When using the IDS (laptop PC)

- Select "Body".
- Select "Security".
- Select "PATS Functions".

- When using the PDS (Pocket PC)

- Select "All Tests and Calibrations".
- Select "PATS Functions".

5. Then, select an item from the screen menu.

- Select the "Program Additional Advanced key"

6. Perform the security access according to the directions on the M-MDS screen. Service and Repair

7. The security access is initiated, and the M-MDS displays, "Acquire security access".
NOTE:
- When "OUT-CODE" is first displayed, turning the ignition switch from the LOCK to the ON position 5 times will change the "OUT-CODE".

8. Follow the instructions on the M-MDS screen, obtain the "IN-CODE" corresponding to the "OUT-CODE".

9. Input the "IN-CODE" corresponding to the "OUT-CODE" displayed on the M-MDS screen.
NOTE:
- After Step 9 is completed and the additional advanced key programming is activated, the door lock actuator operates to lock, and then operates to unlock.

10. Press the UNLOCK button of the unprogrammed advanced key 2 times while in the vehicle.
NOTE:
- After Step 10 is completed and the advanced key is programmed, the door lock actuator operates to lock, and then operates to unlock.

11. If additional advanced keys are to be programmed, go to the additional advanced key programming mode according to the instructions on the M-MDS screen.