Front Seat Removal/Installation

FRONT SEAT REMOVAL/INSTALLATION

WARNING:
- Handling the front seats improperly can accidentally deploy the side air bag, which may seriously injure you. Read air bag system service warnings and cautions before handling the front seats. (See Air Bag System Service Warnings) (See Air Bag System Service Cautions)

CAUTION:
- After removing a front seat, do not operate the slider lever. If the slider lever is operated, the left and right slide positions will deviate, and the slide adjuster may be damaged after the front seat is installed.
- Verify that there are no malfunctions in the sliding mechanism after installing a front seat.
- When performing the procedure with a front seat removed from the vehicle, perform the procedure on a clean rag so as not to damage or soil the seat.
- When the passenger's seat is removed, perform the seat weight sensor inspection using the M-MDS after installing the passenger's seat. (See Component Tests and General Diagnostics)
- When the passenger's seat is replaced with a new one, perform the seat weight sensor calibration using the M-MDS. (See )

1. Turn the ignition switch to the LOCK position.

2. Disconnect the negative battery cable and wait for more than 1 minute.

3. Remove the seat belt anchor. (passenger's side) (See Front Seat Belt Removal/Installation)

4. Remove in the order indicated in the table.










5. Install in the reverse order of removal.