Wheel Hub Component Removal/Installation

WHEEL HUB COMPONENT REMOVAL/INSTALLATION [AWD]

CAUTION:
- Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the wiring harness if it is pulled by mistake. Before performing the following procedures, disconnect the ABS wheel-speed sensor connector (body side) and fix the wiring harness to an appropriate place where it will not be pulled by mistake while servicing the vehicle.

1. Remove the rear ABS wheel-speed sensor. Rear ABS Wheel-Speed Sensor Inspection

2. Remove the rear stabilizer. Rear Stabilizer Removal/Installation

3. Remove the rear coil spring. Rear Suspension

4. Remove the trailing link. Service and Repair

5. Remove in the order indicated in the table.

6. Install in the reverse order of removal.