Hazard Warning Switch: Service and Repair

HAZARD WARNING SWITCH REMOVAL/INSTALLATION

CAUTION:
- The hazard warning switch cannot be reused because it is removed by prying out the connection part of the hazard warning switch panel and hazard warning switch. Do not remove the hazard warning switch except when replacing it.

Removal

1. Disconnect the negative battery cable.

2. Remove the following parts:
a. Decoration panel Decoration Panel Removal/Installation

b. Center panel Center Panel Removal/Installation

c. Audio unit Audio Unit Removal/Installation

3. Remove the screws.






4. Disconnect the connector.

5. Turn the hazard warning switch off.

NOTE:
- Turning off the hazard warning switch provides better visibility of the connection area between the hazard warning switch and the hazard warning switch panel.

6. Insert a tape-wrapped flathead screwdriver in the position shown in the figure, lift it up in the direction of the arrow and shift the tab.






7. Pull out the hazard warning switch in the direction of the arrow shown in the figure.






CAUTION:
- If the hazard warning switch is forcefully removed, the hazard warning switch panel will interfere with the audio panel and cause scratching or other damage. When removing the hazard warning switch, pull it out while pressing the hazard warning switch panel.

8. Remove the hazard warning switch panel in the direction of the arrow shown in the figure.






9. Remove the screw.






10. Remove the short-code from the hook.

Installation

1. Install in the order shown in the figure.










2. Install the following parts:
a. Audio unit Audio Unit Removal/Installation

b. Center panel Center Panel Removal/Installation

c. Decoration panel Decoration Panel Removal/Installation

3. Connect the negative battery cable.