TCM Inspection - AW6A-EL, AW6AX-EL

TCM INSPECTION [AW6A-EL, AW6AX-EL]

Control Module Inspection

1. Remove the air cleaner component. Service and Repair

2. Measure the voltage at each TCM connector (wiring harness-side) terminal and refer to the terminal voltage table.

- If the voltage is not as specified in the Terminal Voltage Table (Reference), inspect the parts under "Inspection item (s)".

WARNING:
- Be careful not to damage the connector waterproofing when measuring the TCM terminal voltage. If damaged, the waterproofing efficiency could be negatively affected.

NOTE:
- Use the ground of terminal A9 of the TCM connector (wiring harness-side) when measuring terminal voltage, as an error may occur when connecting the negative circuit tester to ground.
Terminal Voltage Table (Reference)

Terminal Voltage Table (Reference):

3. Remove the TCM. (See TCM Removal/Installation - AW6A-EL, AW6AX-EL.)

4. Verify that continuity or resistance at terminal is as indicated in the terminal continuity/resistance table.






- If there is any malfunction, inspect the parts under "Inspection item (s)".

- If the system does not work properly even though the parts or related wiring harnesses do not have any malfunction, replace the TCM. TCM Removal/Installation - AW6A-EL, AW6AX-EL
Terminal Continuity/Resistance Table (Reference)

Terminal Continuity/Resistance Table (Reference) (Part 1):

Terminal Continuity/Resistance Table (Reference) (Part 2):

Terminal Continuity/Resistance Table (Reference) (Part 3):

5. Perform the neutral position learning. Programming and Relearning