Carpet: Service and Repair

FLOOR COVERING REMOVAL/INSTALLATION

1. Disconnect the negative battery cable.

2. Remove the following parts:
a. Front seat Front Seat Removal/Installation

b. Rear seat Rear Seat Removal/Installation

c. Joint cover Service and Repair

d. Front scuff plate inner Front Scuff Plate Removal/Installation

e. Rear scuff plate inner Rear Scuff Plate Removal/Installation

f. Front side trim Front Side Trim Removal/Installation

g. Console panel Console Panel Removal/Installation

h. Console Console Removal/Installation

i. B-pillar lower trim B-Pillar Lower Trim Removal/Installation

j. Sub trunk box Sub Trunk Box Removal/Installation

k. Trunk end trim Trunk End Trim Removal/Installation

l. Trunk side trim

m. Selector lever component Service and Repair

n. Selector lever component bracket

o. SAS control module Service and Repair

p. Console bracket

3. Cut away the floor covering as shown in the figure.






NOTE:
- The cut part does not need to match up when installing the floor covering.

4. Remove fastener A, B, C and D.






5. Take the floor covering out from the opened liftgate.

6. Install in the reverse order of removal.