Fuel Delivery and Air Induction: Testing and Inspection
ACCELERATOR SWITCHExc. Wagon
1. Disconnect accelerator switch electrical connector.
2. Connect circuit tester to connector terminals.
3. Ensure continuity when accelerator pedal is depressed.
Wagon
1. Run engine until it reaches operating temperature.
2. Disconnect accelerator switch electrical connector.
3. Connect circuit tester to connector terminals.
4. Ensure continuity when accelerator pedal is depressed.
CLUTCH SWITCH
1. Disconnect electrical connectors of clutch switch.
2. Connect circuit tester to terminals of switch.
3. Ensure continuity when clutch pedal is fully depressed.
NEUTRAL SWITCH
1. Raise and support vehicle.
2. Disconnect neutral switch electrical connector.
3. Connect circuit tester to terminals of switch.
4. On vehicles equipped with automatic transmission, start engine and run at idle, then apply brakes securely.
5. Ensure continuity when shift lever is in neutral and no continuity when shift lever is in any other position.
SLOW FUEL CUT SOLENOID VALVE
1. Apply battery power to solenoid valve.
2. If clicking sound is not heard from valve, replace valve.