Front Suspension Mounting Block - Modification
Category 13Applicable Model/s 1984 626
Subject FRONT SUSPENSION MOUNTING BLOCK
Bulletin No. 025/83
Issued 11/9/83
Revised
UPPER SHEET & SPRING (NEW CONFIGURATION):
DESCRIPTION
To prevent dust from entering the thrust bearing, the following modification has been made.
1. A plain washer has been installed between the mounting rubber and the thrust bearing since the production date of July, 1983.
2. A dust seal has been installed around the thrust bearing, with the change in the configuration of the thrust bearing and upper-spring sheet.
VIN OF PRODUCTION CHANGE
1. Plain Washer
Sedan: JM1GC221 E1601219 July, 1983
Hatchback: JM1GC241 E1600441 July, 1983
Coupe: JM1GC311 E1600676 July, 1983
2. Dust Seal
Sedan: JM1GC221 E1607843 September, 1983
Hatchback: JM1GC241 E1602404 September, 1983
Coupe: JM1GC311 E1603041 September, 1983
PARTS INFORMATION
PART NUMBER
NEW OLD DESCRIPTION QTY APPLIED MODELS INTERCHANGEABILITY
G030 34 382 --- Plain Washer 2 All Models NO
G030 34 016 --- Dust Seal 2 All Models NO
G030 34 381B G030 34 381A Thrust Bearing 2 All Models NEW + P --> OLD
G054 34 340B G054 34 340A Upper Spring Sheet 2 Hatchback, Coupe NO
G030 34 340B G030 34 340A Upper Spring Sheet 2 Sedan NO
Note: If the new thrust bearing is installed to the former vehicles, install the plain washer together with the thrust bearing.