Operation CHARM: Car repair manuals for everyone.

Camber


FRONT




1. Raise and support front of vehicle, then open hood.
2. Remove two shock absorber mounting block to fender attaching nuts.
3. Push mounting block downward and turn it until specified angle is obtained. When triangle mark on mounting block is rotated from engine to the outside, camber changes to negative side. When mark is moved back, camber changes to positive side.
4. Install and tighten two shock absorber mounting block to fender attaching nuts.




REAR

Camber is not adjustable and is set to specifications during production. Whenever camber is moved out of specified angle, check all parts of rear suspension and body alignment. Repair or replace defective part(s) as required.