Camber
FRONT
1. Raise and support front of vehicle, then open hood.
2. Remove four shock absorber mounting block to fender attaching nuts.
3. Push mounting block downward and turn it until specified angles are obtained.
4. Install four shock absorber mounting block to fender attaching bolts. Torque bolts to 22-27 ft.lbs. on 1984-87 models, 29-43 ft.lbs. on 1988 RX-7 and 34-46 ft.lbs. on 1988 626 and MX-6.
REAR
Camber is not adjustable and is set to specifications during production. Whenever camber is moved out of specified angle, check all parts of rear suspension and body alignment. Repair or replace defective part(s) as required.