A/C - Revised Evaporator Installation
Category 15Applicable Model/s 1984 RX-7
Subject
AIR CONDITIONER EVAPORATOR INSTALLATION
Bulletin No. 126/83*
Issued 12/23/83
Revised 3/28/84
Since this service bulletin is a replacement of the previous one, the former category is used. Please discard the previous service bulletin and insert this bulletin into the binder instead of the previous one.
DESCRIPTION
The following modifications must be made when installing a Lone Star air conditioner on 1984 RX-7. If these modifications are not made, the evaporator will not align with the heater case and blower and consequently, air leakage will occur from the seal plates.
REPAIR PROCEDURE
1. Cut the insulation in the area of the upper mounting stud for the evaporator. Cut the insulation as needed to allow the evaporator bracket to bolt directly to the dash frame.
2. Install the evaporator as shown on Block #12 of the RX-7 Air Conditioner Installation Instructions. Route the instrument harness on top of the evaporator approximately 6 inches from the firewall as shown.