A/T - Anchor Bolt Adjustment Manual Correction
Category Applicable Model/s Subject Bulletin No. 015/857 1985 626 ATX PISTON RETURN SPRING Issued 12/3/85
Revised
PISTON RETURN SPRING:
DESCRIPTION
The servo piston return spring was increased in spring force in order to make the shift from 1-2 smoother since the production of March, 1985. Because of this change, the adjustment procedure of the anchor-end bolt as shown in the 626 Workshop Manual, page 7B:73 has been changed.
VIN OF PRODUCTION CHANGE
626 Sedan: JM1GC221 F1734945 March, 1985
Hatchback: JM1GC241 F1708537 March, 1985
Coupe: JM1GC311 F1719269 March, 1985
PARTS INFORMATION
PART NUMBER
DESCRIPTION INTERCHANGEABILITY
NEW OLD
FT40 19 363 0338 19 363 Piston Return Spring NEW --> OLD
ADJUSTMENT PROCEDURE:
ADJUSTMENT PROCEDURE
Anchor-end bolt
After tightening the anchor-end bolt to a torque of 12-15 N-m (8.7-10.8 ft.lbs.), loosen it 3 turns and then tighten the lock nut to a torque of 56-82 N-m (40.5-59.3 ft.lbs.).