Engine, Cooling and Exhaust: Technical Service Bulletins
- Recalls
- Customer Interest
- Engine - Oil Leak At Rear Stationary Gear O-Ring
- Cooling System - Coolant Loss, Warning Lamp ON
- Engine - Hard Cold Start
- Spark Plugs - Hard Start With Cold Engine
- Heater Unit - Noise at 4,000 to 5,000 RPM
- Heater Unit - Noise From the Water Flow
- Eccentric Shaft Pulley Bolt - Revised
- Engine Controls - Misfire and Hesitation Over 6000 RPM
- Engine - Surge or Stumble During Acceleration
- Intake Manifold - Rough Idle After Replacing Gasket
- Water Temperature Switch - Rough Idle
- Engine - Speed Increases Excessively at Cold Starting
- By Symptom
- Abnormal wear/deterioration
- Customer Interest
- Engine - Oil Leak At Rear Stationary Gear O-Ring
- Cooling System - Coolant Loss, Warning Lamp ON
- Engine - Hard Cold Start
- Spark Plugs - Hard Start With Cold Engine
- Heater Unit - Noise at 4,000 to 5,000 RPM
- Heater Unit - Noise From the Water Flow
- Eccentric Shaft Pulley Bolt - Revised
- Engine Controls - Misfire and Hesitation Over 6000 RPM
- Engine - Surge or Stumble During Acceleration
- Intake Manifold - Rough Idle After Replacing Gasket
- Water Temperature Switch - Rough Idle
- Engine - Speed Increases Excessively at Cold Starting
- Driveability
- Leaks
- Loose
- Noise
- Recalls
- Starting problems
- All Technical Service Bulletins
- Campaign - Spark Plug
- Engine - SRT Manual Revision
- Engine - Oil Leak At Rear Stationary Gear O-Ring
- Cooling System - Coolant Loss, Warning Lamp ON
- Coolant - Propylene Glycol Based Not Recommended
- Engine - Hard Cold Start
- Spark Plugs - Hard Start With Cold Engine
- Spark Plug - Gap Modified to Increase Performance
- Spark Plugs - Cleaning Procedure
- Heater Unit - Noise at 4,000 to 5,000 RPM
- Heater Unit - Noise From the Water Flow
- Eccentric Shaft Pulley Bolt - Revised
- Engine - Partial Repair Components Available
- Engine, Rear Oil Seal - Prevent Damage While Assembling
- Engine, Rear Oil Seal - Revised to Prevent Oil Leak
- Engine Rear Oil Seal - Damage Prevention
- Engine Controls - Misfire and Hesitation Over 6000 RPM
- Engine - Surge or Stumble During Acceleration
- Catalytic Converter - Rattle Noise
- Tools - Correct Use of Timing Light on DLI System
- Coolant - Reconditioned Antifreeze, Not Recommended
- Intake Manifold - Rough Idle After Replacing Gasket
- Water Temperature Switch - Rough Idle
- Engine - Speed Increases Excessively at Cold Starting
- Engine - Troubleshooting Hard Start After Heat Soak
- Fuel Injector - Cleaner Kit for Improved Performance