Maintenance: Technical Service Bulletins
- Recalls
- Customer Interest
- Cooling System - Coolant Loss, Warning Lamp ON
- Engine - Hard Cold Start
- Spark Plugs - Hard Start With Cold Engine
- Heater Unit - Noise at 4,000 to 5,000 RPM
- Heater Unit - Noise From the Water Flow
- Engine Controls - Misfire and Hesitation Over 6000 RPM
- Engine - Surge or Stumble During Acceleration
- Intake Manifold - Rough Idle After Replacing Gasket
- Water Temperature Switch - Rough Idle
- Engine - Speed Increases Excessively at Cold Starting
- By Symptom
- Abnormal wear/deterioration
- Customer Interest
- Cooling System - Coolant Loss, Warning Lamp ON
- Engine - Hard Cold Start
- Spark Plugs - Hard Start With Cold Engine
- Heater Unit - Noise at 4,000 to 5,000 RPM
- Heater Unit - Noise From the Water Flow
- Engine Controls - Misfire and Hesitation Over 6000 RPM
- Engine - Surge or Stumble During Acceleration
- Intake Manifold - Rough Idle After Replacing Gasket
- Water Temperature Switch - Rough Idle
- Engine - Speed Increases Excessively at Cold Starting
- Driveability
- Hard Shifting
- Inoperative
- Leaks
- Loose
- Noise
- Recalls
- Starting problems
- All Technical Service Bulletins
- Campaign - Spark Plug
- Antenna - Fuse Removed During Shipping
- Cooling System - Coolant Loss, Warning Lamp ON
- Coolant - Propylene Glycol Based Not Recommended
- Engine - Hard Cold Start
- Spark Plugs - Hard Start With Cold Engine
- Spark Plug - Gap Modified to Increase Performance
- Spark Plugs - Cleaning Procedure
- A/C Compressor Block - Proper Torque of Fitting Bolt
- Heater Unit - Noise at 4,000 to 5,000 RPM
- Heater Unit - Noise From the Water Flow
- Wheel Hub, Front - Bearings Are No Longer Separate
- Tire Chains - Installation Precautions
- Engine Controls - Misfire and Hesitation Over 6000 RPM
- Engine - Surge or Stumble During Acceleration
- Tools - Correct Use of Timing Light on DLI System
- Coolant - Reconditioned Antifreeze, Not Recommended
- Intake Manifold - Rough Idle After Replacing Gasket
- A/T Fluid - Modified to Dextron II
- Transmission Fluid - Correction to Workshop Manual
- Water Temperature Switch - Rough Idle
- Engine - Speed Increases Excessively at Cold Starting
- Engine - Troubleshooting Hard Start After Heat Soak
- Fuel Injector - Cleaner Kit for Improved Performance
- Alignment - Specifications and Revisions
- Alignment - Background Information & Specifications
- A/C Refrigerant - Recommendations
- A/C - R134a Training/Equipment Requirements
- Pre Alignment - Specifications
- Alignment - Toe Control Hub, Bushing
- Wheels - Wheel Lock Installation Precautions
- Wheels - Stain Prevention Information
- Wheels - Aluminum Wheel Cleaning Precautions
- Wheels/Tires - Tire Pessure/Rotation Information