Rear

Wiper System Circuit Diagram:

WIPER MOTOR CIRCUIT CHECK

Rear Wiper Motor Circuit Check:

1. With ignition switch "ON," measure voltage between wire at terminal "LG" and a body ground. It should be approximately 12V.
2. If there is no voltage, check fuse or repair wiring harness.

WIPER MOTOR TESTING

Rear Wiper Motor Testing:

1. Connect battery positive to terminal "LG" of motor connector.
2. Connect battery negative to terminal "BR" of motor connector.
3. Check that motor runs.
4. If not as described, ensure that connections and wiring are in good condition and check again. If problem persists, replace motor.

WINDOW WASHER MOTOR TESTING

Rear Washer Motor Check:

1. With ignition "ON," measure voltage between wire terminal "LG" and a body ground. It should be approximately 12V.
2. If there is no voltage, check fuse or repair wiring harness.
3. If terminal "LG" voltage is okay, connect terminal "LB" to ground.
4. Replace washer motor if it does not operate.