Differential

DIFFERENTIAL
Disassemble the differential in the numbered order shown in the image.




Backlash
Before disassembly, check the backlash of side gears and pinion gears.

Standard backlash: 0-0.1 mm (0-0.004 in)




Knock-pin
To remove the knock-pin from the pinion shaft, place the gear case on a vise and knock the pin out with a 4 mm diameter rod, and hammer.

NOTE: Insert the rod into the knock-pin hole from the ring gear mounting surface side.




Side Bearing Inner Race (side opposite the ring gear)
Remove the bearing inner race from the gear case by using the plate (49 F401 366A) from the bearing remover set (49 B017 1A0) and attachment (49 B092 371).

CAUTION: Hold the gear case with one hand so that it does not fall.




Side Bearing Inner Race (ring gear side)
Remove the side bearing inner race by using a combination of parts from the bearing puller set (49 0839 425C).